Asus DSEB-D16/SAS - Manual (Page 54)

2-34 Chapter 2: Hardware information
5. Intel ® 6321ESB SATA port S/W RAID setting (3-pin RAID_SEL1)
(DSEB-D16 model only)
This jumper allows you to select the Serial ATA RAID configuration utility to
use when you create disk arrays. Both utilities are supported by the
Intel ® 6321ESB. Place the jumper caps on pins 1-2 if you want to use the LSI
Software RAID Configuration Utility (default); otherwise, place the jumper
caps on pins 2-3 to use the Intel ® Matrix Storage Manager (IMSM).
®
DSEB-D16 RAID setting
2 3 1 2
RAID_SEL1
Intel LSI
(Default)
4. Fan control setting (3-pin FAN_SEL1, FAN_SEL2)
These jumpers allow you to switch for fan pin selection. The FAN_SEL1
jumper is for the CPU fans control and FAN_SEL2 is for the other fans control
including front fans, rear fans and FB-DIMM fans. Set to pins 1-2 for 4-pin
fans or pins 2-3 for 3-pin fans.
®
DSEB-D16 Series FAN setting
FAN_SEL1
FAN_SEL2
1 2 2 3
PWM FAN
(Default)
DC FAN
• If you use a 4-pin fan but set the jumper to pin 2-3, the fan you installed
may not work.
• If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan controll will
not work and the fan you installed will always run at full speed.
(CPU Fan)
(Other Fans)