A&D Digital Scale HL-1000WP - Manual (Page 4)

3
PREPARATION
Installing Batteries / Connecting The AC adapter
Installing Batteries
CAUTION
When replacing batteries, be careful
not to apply too much force to the
weighing pan. An excessive force
could damage the scale.
Remove the battery cover and insert six
batteries (R6P / LR6 / AA size) into the
battery compartment, taking extreme
care to that the polarities plus and minus
are observed. Be sure to lock the
battery cover again after installing the
batteries.
AC adapter (optional)
CAUTION
When using an AC adapter, the scale
does not comply with the IP65.
The AC input requirement could be 100,
120, 220, 230 or 240 volts (50/60Hz)
depending on the area where used, so
please verify that the adapter is correct.
Plug the AC adapter to the AC adapter
socket inside the battery compartment.
Attach the battery cover and fit the
rubber cap.
Setting up the HL-WP
CAUTION
Avoid installing the scale in direct sunlight, as that may cause discoloration
or a malfunction. Place your HL-WP on a firm weighing table so that the
scale is level. (The scale will not perform accurately when it is not level.)
Place the scale on the firm surface and adjust the feet so that the sprit level
shows the scale is level for an accurate weighing.
New six batteries (R6P/ LR6/ AA size)
Optional AC Adapter
AC Adapter jack
Close the rubber cap
Battery cover lock