Adesso NuScan 2100 Series - Manual (Page 26)

Start of Configuration
HEADER AND TRAILER
This option allows you to append a header and/or a
trailer to every message transmitted via the serial ports
or the keyboard port. There is no restriction in selecting
header or trailer characters as far as the sum of the
lengths of header and trailer is not greater than 10 digits.
Header
Trailer
Set
1. Select either header or trailer
you are going to program by
scanning the corresponding
label
2. Scan the character(s) you want
from the enclosed ASCII table to
set as header or trailer (be sure
to enable full ASCII code 39
option before you start).
3. Read the “Set” label to set your
choice into memory.
BARCODE IDENTIFIER CODE SELECTION
The series of scanners can transmit max.2-digit barcode
identifier code for different types of barcodes. Use the
labels to choose transmit or not transmit predefined
barcode identifier code (ID’s are listed on page 2):
Enable
Disable
44
BARCODE IDENTIFIER CODE SETTING
Each of the series type scanners can set max.2 digits as
barcode identifier code according to different barcode.
The procedure is as follows:
1. Scan “Start of configuration” label
2. Scan “Barcode identifier setting code” label.
3. Scan the new code mark from ASCII table (max. two
digits). For example, if one “AB” want for code mark
then scan “A” and “B”.
4. Scan “Set” label.
5. Scan “ End of configuration” label.
UPC-E
UPC-A
EAN-13
EAN-8
Chinese post code
ITF 2 OF 5
End of Configuration
45