APW Wyott 93030077 - Manual (Page 5)

4. INSTALLATION INSTRUCTIONS
5. OPERATION INSTRUCTIONS
I. Check Contents:
2. Toaster Placement:
1. Preparation
2. Normal Use
Refer to Figure 1, account for the following parts:
A. Remove foam pad and slide reflector tray in with
wire feeder in upright position as shown.
B. Ensure tray is properly engaged in tray slides. To do this
simply hold the front of the tray higher than the rear as
the back of the tray must slide under the slide on
either side, You will know if done correctly because
tray will be secure. No rocking or teetering will take place.
C. Toast Drawer - shipped in place
D. Instruction Manual - shipped loose
A. Locate toaster near a grounded receptacle of the proper configuration (see below). Plug
the cordset directly into receptacle (DO NOT USEAN EXTENSION CORD).
1. In the U.S.: 208, 230/240V uses NEMA6-20R.
B. Place toaster on flat surface providing following minimum clearances:
1. Base = one inch (provided with legs installed).
2. Side and back walls = two inches
3. Overhead = Enough space to allow adequate heat displacement.
C. Position toaster where customers will not contact any surface labeled “CAUTION HOT”.
A. Clean toaster thoroughly before first use (See cleaning instructions).
B. Controls Familiarity
1. Main Power Switch (located on very bottom of control panel): There are two rocker
switches. The bottom switch powers the unit “ON”. It also turns on the bottom element.
The top switch is a standby switch that runs the top element. When the standby switch is
in the “ON” position the unit is at full power. When the standby switch is in the “OFF”
position the unit is running at 50%.
a) Full Power: Flip both rocker switches to the right.
b) Power Off: Flip both rocker switches to the left.
c) Warm-up time:Allow five (5) minutes.
A. Loading Product
1. Place product on Wire Feeder. The conveyor will automatically draw product through
the toaster at a speed determined by conveyor speed control.
2. Conveyor Speed Control: Set knob to the three (3) position for warm-up.
B. Toasting Darkness: determined by conveyor speed & thermostat control.
1. Darkest toasting - set conveyor speed control to far left setting & thermostat controls to
highest setting.
2. Lightest toasting - set conveyor speed control to far right setting.
3. Other factors affecting toasting darkness.
3. Thermostat Controls:
A. The top thermostat runs the top element & the bottom thermostat runs the bottom element.
Figure 1
C
B
A
5
!
WARNING: Operating toaster without Reflector Tray reduces toasting capabilities.
!