Ariston LSI 61UK - Manual (Page 5)

4
ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
You have loaded your dishes and you now have
to set the wash cycle. It takes just one minute
to learn how
Starting the dishwasher
Ready, steady, go!
First of all.
After performing all the operations
described in the previous para-
graphs, turn the water tap on com-
pletely, open the appliance door and
press ON-OFF button "A": indica-
tor light "B" comes on. Your appli-
ance is now on and awaiting in-
structions.
Selecting the wash
cycle.
Select the wash cycle by pressing
button "P". Each time this button
is pressed, one of the indicator
lights "M" will come on in sequence,
select the wash cycle you deem
most suitable for the type of dishes
to wash (take a look at page 5,
where you will find the wash cycle
table). Close the appliance door and
after a few seconds, the wash cy-
cle will begin.
Modifying a wash cycle in
progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Open the appli-
ance door carefully to avoid any
hot water splashes, then keep but-
ton "P" pressed for approximately
5 seconds . Indicator light "M" will
come off and at this point, all the
settings will have been cancelled.
You are now free to re-set the cor-
rect wash cycle.
You've left out a dish?
Well, it happens to everyone. Inter-
rupt the wash cycle by opening the
appliance door with the utmost
care, as usual, then insert the dish
you had forgotten. When you shut
the appliance door, the cycle will
start up from where you interrupted
it.
Finished?
The end of the wash cycle is indi-
cated by the flashing of the wash
cycle indicator light "M". Open the
dishwasher door, press the ON-OFF
button as well, thus cutting off the
electricity supply to the appliance.
Turn off the water tap.
Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry
better thanks to the steam. Empty
the upper rack first.
There's been a power fail-
ure? Have you opened the
dishwasher door?
The wash cycle stops and then re-
starts when the electricity comes
back on or when you shut the door.
Everything is under control!
Make sure the
wash cycle has
ended before
removing the
dishes!
Select the right
wash cycle for
your dishes.
Selecting the
most suitable
wash cycle for
the load ensures
clean dishes and
a more
convenient use of
water and
electricity.
W a r n i n g :
When you open the
dishwasher door
after the wash cycle
has just ended or is
under way, take
care not to scald
yourself with the
hot steam!