Preparing the remote control, Compatible ipod and iphone, Charging the ipod or iphone – Panasonic SC-SP100 User Manual

Page 7

Advertising
background image

7

RQTX1009

ENGLISH

7

ESP

AÑOL

ENGLISH

Preparing the remote control

Before using the remote control for the fi rst time, remove the insulation
sheet.

Replace the remote control battery when it stops operating, or when
the range seems reduced.

Rear view

Pull

CR2025

Lithium
Button-Type
battery
(CR2025)

1 Insert an object and push down

to unlock the catch.

Aim at the remote control signal sensor (

\ page 9), avoiding

obstacles, at a maximum range of 7 m directly in front of the main unit.

• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct

sunlight for a long period of time with doors and windows closed.

• Remove the battery if the remote control is not going to be used for a

long period of time. Store in a cool, dark place.

CAUTION
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.

Warning
Risk of fi re, explosion and burns. Do not recharge, disassemble,
heat above 60°C or incinerate.

Compatible iPod and iPhone

• iPhone 3G (8GB, 16GB)
• iPhone (4GB, 8GB, 16GB)
• iPod touch 2nd generation (8GB, 16GB, 32GB)
• iPod nano 4th generation (video) (8GB, 16GB)
• iPod classic (120GB)
• iPod touch 1st generation (8GB, 16GB, 32GB)
• iPod nano 3rd generation (video) (4GB, 8GB)
• iPod classic (80GB, 160GB)
• iPod nano 2nd generation (aluminum) (2GB, 4GB, 8GB)
• iPod 5th generation (video) (60GB, 80GB)
• iPod 5th generation (video) (30GB)
• iPod nano 1st generation (1GB, 2GB, 4GB)
• iPod 4th generation (colour display) (40GB, 60GB)
• iPod 4th generation (colour display) (20GB, 30GB)
• iPod 4th generation (40GB)
• iPod 4th generation (20GB)
• iPod mini (4GB, 6GB)

Compatibility depends on the software version of your iPod or iPhone.

Charging the iPod or iPhone

• The iPod or iPhone charges automatically when power is supplied to

the main unit.

• Check iPod or iPhone to see if the battery is fully recharged.
• If you are not using the iPod or iPhone for an extended period of

time after recharging has completed, disconnect it from the main
unit, as the battery will be depleted naturally. (Once fully recharged,
additional recharging will not occur.)

RQTX1009-1R_gb_es_pl_cz_ru_ua.in7 7

RQTX1009-1R_gb_es_pl_cz_ru_ua.in7 7

7/2/09 5:48:28 PM

7/2/09 5:48:28 PM

Advertising