Panasonic ES2067 - Manual (Page 3)

3
English
epilation discs can be damaged.
The movement of the discs makes some noise but this is perfectly normal.
Keep the appliance out of the reach of children or invalids.
Do not leave the appliance near sinks, bathrooms or other high-humidity
areas where it could be exposed to water and moisture after use.
The followings might cause mechanical malfunction.
Using nail polish remover, benzine, alcohol, etc. to clean the appliance.
Leaving the appliance where it will be exposed to high temperatures or
direct sunlight.
Contact an authorized service center if the epilator or the cord get
damaged.
Changing the head
Before use
1. Remove the head while holding the head release button.
2. Push the head until it clicks.
Charging the appliance
Charging


1. Plug the charger into the epilator
() and a household outlet ().
2. Charge the appliance for
approximately 1 hour. (Charging is
completed when the charging light
blinks.)
The epilator can be used for
approximately 30 minutes after 1 hour charge.
While charging: Red light appears.
After charging is completed:
Blinks once every second.
10 minutes after charging is completed:
Blinks once every 2 seconds.
Abnormal Charging: Blinks twice every second. •
•
•
•
The charge light may not turn on after a few minutes in some cases.
However, it will turn on eventually if you continue charging.
The appliance can be left plugged in after it is fully charged without
deteriorating the battery life.
The recommended charge temperature is 15-35 °C.
If you use the charger in temperature outside of the recommended range,
the following problems might occur.
The time it takes to charge the appliance increases. (approximately 3 hours)
The charger stops functioning.
•
•
•
•
-
-
•
•
•
•
•
-
-
ES2067_EU.indb 3 2007/11/26 18:28:44