Acura 2009 MDX - Manual (Page 83)

Navigation System 83
System Setup
Setup Mode
The Setup function consists of two main
screens that allow you to change and
update information in the system. To
display the
Setup screen (first), use the
voice control system and say “Setup” or
press the
SETUP button. To change to
the Setup screen (second), say or select
MORE in the upper right corner of the
screen.
You can use the voice control system to
select any item on the
Setup screen.
NOTE:
• If some items appear to be grayed out
and cannot be selected, it is because
you did not select
OK on the initial
Disclaimer screen. See System Start-
up on page 17 .
• Setup items in this manual with the
symbol indicate that the
display settings depend on what
“Driver #” was displayed on the MID
when the vehicle was started. See
Remote Keyless Entry Setting on
page
18 .
• If only “Welcome” is displayed, then
all Setup settings revert to factory
defaults, and all personal data (such
as Address Book or Calendar) are not
available.
• For information on the available
voice commands, see Voice
Command Index on page
164 .
Setup Screen (first)
From any screen, say “Setup screen” or
press the
SETUP button, and the
following screen appears:
Brightness
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say “Brightness up”
or “Brightness down.” You can also
select
Brightness and change the
setting by rotating the Interface Dial
knob .
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
2009 MDX
Main Menu