Balboa Water Group Adjustable VSR Retrofit Kit User Manual
Balboa Water Group Accessories for water
Installation Instructions Adjustable VSR Retrofit Kit
Material and tools required:
PVC Glue and applicator (not included in the kit)
UÊ
A cloth rag (not included in the kit)
UÊ
Instructions:
1. Drain the water level below the jet being worked on from the SPA. See Picture 1 below.
2. Turn off all the electrical power to the SPA. Ensure that heater and water pump are turned off.
3. Remove the handle assembly from the existing jet body by rotating the handle clockwise.
Some force may be needed to remove the handle due to water salt build up.
4. Clean and dry inside wall of the existing jet body as illustrated in Picture 2 below.
Picture 1
Picture 2
5. Apply PVC glue with applicator in the jet body area as illustrated in Picture 3 below.
6. Orient the tab of the retrofit retaining ring towards the jet such that the tab will insert on the inside wall slot of the
jet body as illustrated in Picture 4 below.
Picture 3
Apply PVC glue
on this wall
Area of coverage
should be 3/4” wide
from this shoulder
Page 1 of 2
42011 A June 4, 2010