Balboa Water Group Micro Jet - Manual

979500 Rev B August 24, 2009
Micro Jet Installation Instructions
Cut a hole in the spa wall 1 5/8 inches in diameter. 1.
Position the gasket on the wall flange, see Figure 1. 2.
Insert the wall flange into the drilled hole. 3. It is very important that the spa surface is clean to
insure a proper seal between the spa wall and the gasket.
Apply a small amount of silicone to the flange threads from the back of the spa.
4.
Insert the Installation Tool into the recesses in the wall flange face. 5.
Thread the jet body onto the wall flange from the backside of the spa. 6.
Holding the wall flange, tighten the body onto the wall flange until hand tight. 7.
Be sure the air and water plumbing ports are lined up at their desired position. 8.
Insert a torque wrench into the Installation Tool, P/N 45271700, and tighten it to a minimum of 4 9.
foot pounds, to a maximum of 5 foot pounds.
(cont. other side)
CAUTION
Do not over tighten as this may cause damage to parts and leakage may occur.
Make the appropriate plumbing connections to the jet body. Be sure the glue is not allowed to run into 10.
the jet body.
Note
Refer to the Glue manufacturer specifications for material compatibility with PVC and Vinyl tubing.
Install the barrel assembly into the jet body by inserting and rotating the barrel with light pressure until 11.
it snaps into place. It will move freely to the left and right without pulling out.
Note
To remove the barrel assembly, place the flat blade of a screwdriver between the barrel assembly and
the wall flange. Lift up on the screwdriver until the barrel assembly comes out of the spa wall.
Silicone is recommended to be used with
the Micro gasket. Some Silicone’s are not
compatible with the materials used in this
product. Refer to your Silicone Manufacturers
specifications for material compatibility.
CAUTION