CatEye CC-RD420DW [Strada Digital Wireless] - Manual (Page 2)

CC-RD420DW ENG 2 How to install the unit on your bicycle
3 mm
When attaching the FlexTight™ bracket to the stem :
1
Attach the bracket to the stem or handlebar
The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on how the bracket fits into the bracket band.
Caution: Be sure to tighten the dial of the FlexTight™ bracket by hand.
Tightening it strongly using a tool, etc. may damage the screw thread.
2
Install the speed sensor to the front fork or
chain stay
* The speed sensor can be used either installed to the front fork
or chain stay.
Remove/Install
the computer
Bracket
band
Speed sensor
(SPD-10)
Sensor rubber
pad
Nylon ties
(x 2)
Magnet
Bracket band
Bracket band
Handlebar
Click
Dial
Cut
Cut
While supporting it by hand,
Push it out as if lifting
the front up
Stem
Bracket Bracket
Bracket
Dial
Bracket rubber
pad
Bracket rubber pad
Bracket rubber pad
Sensor
rubber pad
Speed
sensor
Nylon ties
Pull
securely
Magnet
Spoke
Magnet
Magnet
SENSOR ZONE Speed sensor
Speed sensor
Magnet
Speed
sensor
SENSOR ZONE
To the SENSOR ZONE
When attaching the FlexTight™ bracket to the handlebar :
When installing to
the front fork:
When installing to
the chain stay:
Install the sensor and
magnet
The magnet
passes through
the sensor
zone.
The clearance
between the sen-
sor and magnet is
3 mm or less.
Caution:
Round off the cut
edge of the bracket
band to prevent
injury.
* To mount the bracket to an aero-shaped handlebar or larger stem, use the optional nylon ties
bracket.
* The magnet may be installed any-
where on the spoke if the above
installation conditions are satisfied.
1
2