CatEye HL-EL460RC [Volt300] - Manual

RECHARGEABLE HEADLIGHT
HL-EL460RC
Manual
1. Connect the light unit to your PC or
a commercial USB battery charger
using the USB cable. (Fig 1 1 – 2)
The switch or the indicator on the
cradle lights up, and charging starts.
Indicator light: On Charging
Indicator light: Off Charging is completed
* When your PC is in sleep state, the
unit cannot be charged.
* We recommend using 500+mA
(USB2.0) USB battery charger.
2. After charging is completed, remove
the USB cable, and install the charge
jack cover.
* Charging and lighting times are ap-
proximate values, and will vary by en-
vironmental and user conditions.
* The cartridge battery can be fast-
charged by using the optional charging
cradle (about 3 hours of charging time).
Use a 1A or higher USB charging
adapter when charging by the cradle.
Before using the light, please read this manual and
the attached “Lithium-ion Batteries” thoroughly, and
keep them for future reference.
5
Rubber pad
Bracket
HOW TO CHARGE 1
*1
CAUTION!
• Before your trip, please make sure the light is fi rmly mounted to
the bracket and it lights up.
• Do not place it within children’s reach.
• In preparation for unexpected battery shutoff, we recommend you
carry a spare cartridge battery and light.
• Mounting the light unit too close to a wireless computer may
adversely affect the reading of the computer.
• This product is water-resistant under normal daily use and can
be used in the rain. However, do not intentionally submerge it in
water.
• If the light unit or parts become dirty with mud, etc., clean with a
soft cloth which is moistened with mild soap. Never apply paint
thinner, benzine or alcohol; damage will result.
• Dispose of used cartridge batteries appropriately according to
local regulations.
Before Initial Use
This unit is shipped with a small charge to check the light.
Be sure to charge it before use, according to the instructions
“HOW TO CHARGE”.
1. Mount the bracket to the handlebar.
(Fig 2 1 – 3)
2. Insert the light unit into the bracket
until it clicks, and adjust the beam
angle. (4)
3. To remove the light unit, pull out it
forward while pressing down on the
release button (5).
* To re-adjust the beam angle, loosen
the dial enough to move the bracket,
and fi rmly tighten it after adjustment.
* The light can be mounted under the
handlebar.
CAUTION!:
• Be sure to tighten the dial by hand.
When you tighten it too hard with
a tool, the screw thread may be
stripped.
• Check the dial and screw (*1) on the
bracket periodically, and use them
without any loosening.
• Round off the cut edge of the bracket
strap to prevent injury.
HOW TO MOUNT 2
Standard
charging time
Approx. 6 h
(USB 2.0)
2
3 1
2
1
Strap
4
5
Dial
Release
button
Screw
Cradle
USB cable
Charge jack
cover
To PC or USB
battery charger
Charging on the cradle
Cartridge
battery
Indicator
Design Pat. Pending
Copyright© 2013 CATEYE Co., Ltd.
EL460RC-130612 4
*1
Cartridge battery
FlexTight™ bracket
(H-34N)
USB cable
Light unit
ENG