CatEye HL-EL625RC [Nano Shot+] User Manual

Nano shot, Rechargeable headlight, Hl-el625rc

Advertising
background image

RECHARGEABLE HEADLIGHT

Nano Shot

+

HL-EL625RC

ENG

Copyright© 2012 CATEYE Co., Ltd. EL625RC-120518

2

1

2

3

SPECIFICATIONS

Light source

High-intensity white LED x 2

Battery

Li-ion 3.7v 2800mAH

Charge

Mini USB plug

Operating time

Hi

: Approx. 1.5 hours

Low

: Approx. 4 hours

HyperConstant : Approx. 2 hours

Standard charging time

Approx. 8 hours (USB2.0)

Temperature range

Charging

: 41˚F – 104˚F (5˚C – 40˚C),

Operating

: 14˚F – 104˚F (-10˚C – 40˚C)

Recharge/discharge number of times About 300 times (until the rated capacity drops to 70%)
Dimensions/weight

3-51/64” x 2-5/16” x 1-13/32” (96.4 x 58.6 x 35.6 mm) / 5.64 oz (160 g)

(Including rechargeable batteries supplied)

The specifi cations and design are subject to change without notice.

*

Standard operating time

Hi

Approx. 1.5 h

Low

Approx. 4 h

HyperConstant Approx. 2 h

2-8-25, Kuwazu, Higashi Sumiyoshi-ku,

Osaka 546-0041 Japan

Attn: CATEYE Customer Service Section

Phone : (06)6719-6863

Fax

: (06)6719-6033

E-mail : [email protected]

URL : http://www.cateye.com

[For US Customers]

CATEYE AMERICA, INC.

2825 Wilderness Place Suite 1200,

Boulder CO80301-5494 USA

Phone

: 303.443.4595

Toll Free : 800.5CATEYE

Fax

: 303.473.0006

E-mail

: [email protected]

CO.,LTD.

Before using the light, please read this manual and the attached “Lithium-ion Bat-

teries” thoroughly, and keep them for future reference.

LIMITED WARRANTY

2-year Warranty: Light unit only (Deterioration of the battery is excluded.)

CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from

original purchase. If the product fails to work during normal use, CatEye will repair or replace the defect at no

charge. Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and

enclose the warranty certifi cate (proof of purchase) with instruction for repair. Please write or type your name and

address clearly on the warranty certifi cate. Insurance, handling and transportation charges to CatEye shall be borne

by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase.

This does not affect your statutory rights.

Please register your CatEye product on the website.

http://www.cateye.com/en/support/regist/

SPARE PARTS

5338827N

FlexTight™ bracket (H-34N)

Attach the bracket to the handlebar as shown. (

1.

1

-3)

Insert the light unit to the bracket until it clicks, and adjust the beam angle. (

2.

4

)

To remove the light unit, pull out it forward while pressing the button (

3.

5

).

To re-adjust the beam angle, loosen the dial enough to move the bracket, and securely

*

tighten it after adjustment.

CAUTION!:

Be sure to tighten the dial by hand. When you tighten it too hard with a tool, the

screw thread may be stripped.
Check the dial and screw (*1) on the bracket periodically, and use them without

any loosening.
Round off the cut edge of the bracket strap to prevent injury.

The ON/OFF and lighting modes are selected using a switch.

Connect the light unit and your PC, or a commercial USB battery charger with the

1.

USB cable (1-2) as shown. The switch lights up, and charging starts.

When the switch turns green, charging is complete. Remove the USB cable, and

2.

install the charging jack cover.

When your PC is in sleep state, the unit cannot be charged.

*

With USB1.0, it takes time to charge.

*

Flashing light of the switch shows that a charging error has occurred. Remove and

*

reinsert the USB cable, then begin the recharge process again.

Flashing red light

The battery charger is defective or the battery has deterio-

rated

Flashing yellow light An inappropriate battery charger is connected

The battery charges to about 80% after approximately 5 hours.

*

Charging and lighting times are approximate values, and will vary by environmen-

*

tal and user conditions.

CAUTION!

Before your trip, please make sure the light is fi rmly mounted to the bracket, it

lights up, and the light is not blocked by baggage, etc.
Do not place it within children’s reach.

In preparation for unexpected battery shutoff, we recommend you carry a spare light.

Mount the light unit more than 5 cm away from the wireless meter. When it is

mounted too close, the transmission may be affected adversely.
This product is water-resistant under normal daily use and can be used in the

rain. However, do not intentionally submerge it in water.
If the light unit or parts become dirty with mud, etc., clean with a soft cloth

which is moistened with mild soap. Never apply paint thinner, benzine or alco-

hol; damage will result.
Remove the used battery and bring it with the connector covered with an insula-

tion tape to the store supporting rechargeable battery recycling.

Before Initial Use

This unit is shipped with a small charge to check the light. Be sure to charge it be-

fore use, according to the instructions “HOW TO CHARGE”.

3

4

5

1

2

1

2

USB cable

Charge jack cover

Dial

Rubber pad

Bracket

Strap

Release

button

Screw

*1

To PC or USB battery charger

Double press

1 sec.

Hi

Hi

Low

Low

*2

HyperConstant

OFF

HyperConstant

*2

1 sec.

ON

Light unit

FlexTight™ bracket

(H-34N)

USB cable

HOW TO MOUNT TO A BICYCLE

HOW TO CHARGE

SWITCH OPERATION (SWITCHING THE LIGHTING MODE)

HOW TO REPLACE THE BATTERY

When the operating time decreases signifi cantly, the battery life is close to an end.

Please contact CatEye local distributor listed on our website www.cateye.com or Cat-

Eye for replacing battery.
CAUTION!: The light unit is a precision device. Never disassemble it.

DISPOSE BATTERY

1

2

3

4

Battery

Standard charging time

Approx.

8 h

(USB 2.0)

Switch (indicator)

Red light: Charging

Green light:

Charging is completed

*2 When you turn the unit on, or when you switch from HyperConstant to Hi or Low,

the unit will light up in the previous mode.

(Mode memory function)

Remaining battery capacity

When the light unit is on, the color of the switch shows how much battery power remains.

Green light

The remaining battery level is suffi cient.

Orange light

Battery power is less than 50%.

Red light

The remaining battery level is low. Charge the battery.

Advertising