EXONIC EXD 7082 - Manual (Page 19)

87.50
FM1
MHZ
DX ST
1 2 3
6 5 4
87.50 90.00 98.00
86.50 107.00 106.00
Radio APS EQ
-18-
In Radio Mode, touch and keep (for more
than 2 ’ S) the screen of
range to
active automatic station storage.
The radio searches within the current
frequency band, e.g. FM1, for the stron-
ger signal level until the search cycle
has finished . The six strongest stations
are then allocated to the corresponding
storage locations . Then the station of
the first storage location is set .
“ APS ”
Automatic Memory Storing &
Program Scanning
Automatic Preset Setup
Scan Function
In Radio mode, briefly touch the
section on the touch screen , the radio
briefly plays all the preset stations of the
frequency band . “APS”
Touch Screen Operation
- Store in Memory
- Retrieve a preset station
1-6
>Select the frequency band .
>Select the station .
>Keep the desired memory key pressed
in until the station is heard again after
a brief interruption .
Touch the ranges briefly to retrieve
a station which had been stored in the
memory in advance the chose number
is shown on display .
Start Searching For a Station
During Radio mode, briefly touch the
screen of “
” section to increase
frequency by one step of channel
spacing . Briefly touch the “
” section
to decrease frequency by one step of
channel spacing .
During Radio mode, touch and hold
(for more than 2’s ) the screen of “
/ ”
section to start search for a radio
station automatically .
Automatic Search
Manual Search
Storing and Listening to a
Memory Station
With this system, a total of 30 stations
can be stored in the memory of six
buttons. Each band stores up to six
preset stations.
The operation is as below :
To tune in strong-singnal FM
Station only (LO/DX function)
In home menu, then touch the
icon to enter the setting menu, the
message will display as below : “ SET ”
SET
RADIO LOC/DX
RADIO STEREO
DX
LOUDNESS
87.50
FM1
MHZ
DX ST
1 2 3
6 5 4
87.50 90.00 98.00
86.50 107.00 106.00
Radio APS EQ