EXONIC EXD 7095 - Manual (Page 18)

-18-
6. APS BUTTON
Automatic Memory Function:
In Radio mode, press longer (more than 2’s) the APS button to active automatic
station storage. The radio searches within the current frequency band, e.g. FM1,
for the strongest station are then allocated to the corresponding storage
locations. Then the station of the first storage location is set. If you would like to
search for more stations in the FM band, press the BND button in order to change
to the FM2 or FM3 band. Press it again for about 2 seconds to continue search.
Program Scan Function:
In Radio mode, press shortly the APS to scan and play all the preset stations in
order, and it will hold at each band for about 5 seconds . If you like one of them,
press the PLAY/PAUSE button to stop the scanning .
7. MU BUTTON
Press it button to switch of the loudspeakers for a short period. The word MUTE
flashes in the display. Press it again to cancel the mute function. This function
can also be cancelled by rotating the VOL multifunction button.
5. EQ BUTTON
Press briefly the EQ button to turn to equalization function and to select desired
audio mode. There are five kinds of mode as below:
JAZZ CLAS POP ROCK FLAT
Press and hold (more than 2’s) the EQ button to switch the Loudness function
ON and OFF .
8 /CH 1-6 (RADIO PRESET) BUTTON
A) In Disc Playback Mode
Press this button to pause playback, press it again to resume playback.
B) In Radio Mode
Press this button repeatedly to preset station. With this system a total of 30
stations can be stored in the memory . Each band store up to six preset
stations. The stations might be FM1, FM2, FM3, AM1 (MW1) and AM2
(MW2) band.
Follow the instructions below:
-Store in Memory
> Select the frequency band
> Press repeatedly the button to select the desired memory key .
> Select the station
> Keep the desired memory key pressed in until the station is heard again
after a brief interruption .
- Retrieve a preset station
press the button repeatedly to retrieve a station which had been stored in the
memory in advance the chose number is shown on display .
Control Panel