Adams 22 - Manual (Page 16)

MAINTENANCE
16
F-050414L
BLADE SERVICE
WARNING: Before you inspect
the blade or the blade adapter,
disconnect the wire to the spark
plug. If the blade hits an object, stop the
engine. Disconnect the wire to the spark
plug. Check the unit for damage.
Frequently check the blade for wear or dam-
age such as cracks. Frequently check the bolt
that holds the blade. Keep the bolt tight. If the
blade hits an object, stop the engine. Discon-
nect the wire to the spark plug. Check the
blade adapter for damage. Check for a bent or
damaged blade, a badly worn blade, or other
damage. Before you operate the unit, dam-
aged parts must be replaced with factory re-
placement parts. For safety, replace the blade
every two years. Keep a sharp edge on the
blade. A blade that is not sharp will cause the
ends of the grass to become brown. Remove
the blade as follows.
HOW TO REMOVE THE BLADE
WARNING: Before you remove
the blade, disconnect the wire to
the spark plug. The blade has
sharp edges. When you hold the blade,
use gloves or cloth material to protect
your hands.
1. Drain the fuel tank.
2. Lift the side of the mower that has the
muffler or spark plug.
3. Use a piece of wood to keep the blade
from rotating.
4. Remove the bolt that holds the blade with
a 9/16” (14mm) wrench.
Blade Adapter
Blade
Belleville
Washer
Washer
Bolt
Figure 13
ООООО
ПППП
ПППП
ОО
ОО
ОО ППП
ППП
ПП
ПП ООО ОО
ММ
Belleville Washer
Mulching
Blade
Bolt
Blade Adapter
Flat Washer
5. Check the blade according to the ”Blade
Service” instructions. Replace a badly
worn or damaged blade with a factory re-
placement blade.
6. Mount the blade with the curved edges to-
ward the housing. If the blade is upside
down, the blade will not cut correctly and
can cause an accident.
7. Fasten the blade with the original wash-
ers and bolt. Make sure the outside rims
of the Belleville washers are toward the
blade (Figure 13).
8. Tighten the bolt that holds the blade to a
torque of 30 foot pounds.
WARNING: Always keep the
bolt that holds the blade tight. A
loose bolt or blade can cause
an accident.
HOW TO SHARPEN THE BLADE
WARNING: Vibration is the result
if the blade is not correctly bal-
anced. A blade that is damaged
with cracks can break and cause an acci-
dent.
1. Sharpen the blade two times a year or ev-
ery 25 hours.
2. If the blade is on the unit, do not sharpen.
Remove the blade according to the in-
structions in ”How To Remove The Blade”.
3. Clean the blade with a brush, soap, and
water. Check the blade. Look for cracks,
nicks, or other damage. Replace a blade
that is badly worn, bent, or damaged with
a factory replacement blade.
4. Sharpen the blade with a file. Make sure
you keep the original beveled cutting edge
(Figure 14).
(Continued following page)
Ground
Blade is balanced
when parallel to
the ground.
Screwdriver
Blade
File
Figure 14