Power Soak MX-220-HTS Owner's/Service Manual - Manual (Page 52)

51
Installation Guide
The installation and initial operational check of your new system
must be performed only by licensed and certified plumbers and
electricians.
Be sure to follow all applicable national and local electrical codes
when installing the electrical supply and/or a new breaker. DO NOT
connect the system using a power cord and plug or an extension cord
of any kind.
Please refer to the detailed installation instructions that were sent with your Power Soak
system.
Providing Proper Electrical Service
The requirements of your new system are on the serial number plate located on the front of
the wash sink, adjacent to the control panel enclosure and inside the enclosure itself.
All PowerSoak systems have a single point electrical connection, and a dedicated circuit is
required.