Power Soak 36212 PS-275 Owner's Manual User Manual
Page 28
24
Facility Owner/Manager Section
The only troubleshooting procedure that the facility
owner or manager can perform is listed immediately
below. All other procedures must be performed by an
authorized service agency. To obtain the name of a
recommended service agent in your area, please call
the Power Soak Service Department at 800-444-9624.
If the wash action will not start:
• Check to make sure the main electrical power breaker for the Power
Soak machine is in the “ON” position.
• See that the wash tank is filled to the waterline.
• Examine the liquid level sensors to see that they are clean and free
of any debris or grease. The liquid level sensors are located on the
side walls of the wash and sanitizer tanks (the white plastic disc with
a metal center).
• Make sure the temperature of the water in the wash tank is below
128F.
If the above trouble shooting procedures do not correct the problem,
contact Power Soak Systems, Inc. at 800-444-9624 or an authorized
service agency. Have the serial number of the machine ready when the
call is placed.