Silver King SKCTD1 - Manual (Page 2)

1
TECHNICAL MANUAL
COUNTERTOP DISPLAY REFRIGERATOR
MODELS SKCTD1, SKCTDST1 AND SKCTDPT1
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the
most reliable equipment in the industry today. Please read this manual and the accompanying warranty
information before operating your new Silver King unit. Be sure to complete and mail the warranty card
within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following
the instructions printed on the exterior of the container. Report any damages to the carrier responsible for
transportation and promptly present a claim for any evidence of mishandling. Save all packaging materials
if a claim is filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing
and shipping. This covering can be readily stripped before installation. After removing this covering, wash
the interior and exterior surfaces using a warm, mild soapy water solution and a sponge or cloth, rinse with
clean water and wipe dry.
Legs
The display refrigerator comes with four legs. To install them, tip the unit and thread them into the four
threaded holes in the bottom of the cabinet.
Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with
the “tang” go on the rear Pilasters. This shelf system allows for easy adjustment to suit your needs.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the
following installation guidelines must be followed;
*Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that
would affect the operation of the unit.
*For proper ventilation the unit requires the following minimum clearances:
- 1 inch on the sides and back.
- open above the cabinet and in front of the doors.
- 4 inch legs are to be attached to the unit.
*The unit must be level or tilted backwards slightly.
*When placing the unit on a counter or shelf the structure must be able to support a
minimum of 260 pounds.