Silver King SKF2A User Manual

Page 2

Advertising
background image

1

TECHNICAL MANUAL

SILVER KING REFRIGERATED FOUNTAINETTE

MODEL SKF2A

Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable

equipment in the industry today. Please read this manual and the accompanying warranty information before operating your new

Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.

INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to examine and test for possible damage following the instructions

printed on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a
claim for any evidence of mishandling.

INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a

warm, mild soapy water solution and a sponge or soft cloth, rinse with clean water and wipe dry.

Location
When locating your new Silver King unit, convenience and accessibility are important considerations, but the following installation

guidelines must be observed;

• Always avoid locating the unit adjacent to an oven, heating element or hot air source which could adversely affect the

performance of the unit.

• The unit must be level or tilted slightly to the back to allow proper drainage of the condensate and to allow the door to close

and seal.

• When installing the Model SKF2A Fountainette, if the unit is not on casters, it is designed to be sealed to the floor with a

waterproof sealant as required by NSF International. To do so, locate the unit in its desired location (following the installation

instructions), apply a bead of sealant around the perimeter of the unit at the base and smooth out with a finger to form a

radius with the floor and the unit. For proper ventilation, the bottom front grill area of the unit must not be obstructed.

Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with the “tang” go on the rear

Pilasters. This shelf system allows for easy 1/2 inch height adjustment to suit your needs.

Accessories
Your Fountainette comes with four or five stainless steel pans with covers and two ladles. The refrigerated rail area holds five syrup

jars and pumps. Also included is a removable, easily cleanable drip tray.

Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to a power

source. The data plate specifications supersede any future discussion.


The standard unit is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle, 1 Phase properly grounded

electrical receptacle. The power cord comes with a 3 prong plug for grounding purposes. Any attempt to cut off the grounding

spike or to connect to an ungrounded adapter plug will void the warranty, terminate the manufacturers responsibility and could result

in serious injury.

The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an

extension cord.

Advertising