Silver King SKUCF7F/C4/C13/CEU3 - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING FREEZER
MODEL SKUCF7F
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable
equipment in the industry today. Please read this manual and the accompanying warranty information before operating your new
Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following the instructions printed on the
exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any
evidence of mishandling.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a
warm, mild soapy water solution and a sponge or cloth.
Legs/Casters
The unit comes with Legs or Casters. To install them, tip the unit on to its side and thread the Legs or Casters into the 4 Rivnuts in
the base of the unit. Make sure that they are installed tightly to prevent future thread wear.
Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with the “tang” go on the rear
Pilasters. This shelf system allows for easy adjustment to suit your needs.
Door Adjustment and Swing
Should the Door ever require straightening, loosen the Screws on the Hinges, square the Door with the cabinet and retighten the
Screws.
The mounting of the door is easily reversible should space requirements demand that you do so. Simply remove the 3 Screws
holding each Hinge in place, rotate the Door 180 degrees and relocate the Hinges in the corner opposite their original location.
Location
When locating your new freezer, convenience and accessibility are important considerations, but the following installation guidelines
must be followed;
• Always avoid placing the freezer adjacent to an oven, heating element or hot air source that would affect the operation of the
unit.
• For proper ventilation the unit requires the following minimum clearances:
- 6 inches in back
- 4 inches on the sides and 2 inches above the cabinet
• The unit must be level or tilted backwards slightly.