Silver King SKPZ92D1/C8 - Manual (Page 2)

1
TECHNICAL MANUAL
SILVER KING PREPARATION TABLES
MODEL SKPZ92D1/C8
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable equipment
in the industry today. Please read this manual and the accompanying warranty information before operating your new Silver King
unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed
on the exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for
any evidence of mishandling. Save all packaging materials if a claim is filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a
warm, mild soapy water solution and a sponge or cloth, rinse with clean water and dry.
Legs/Casters
The unit comes with Legs or Casters. To install them, tilt the unit and thread the Legs or Casters into the 4 or 6 mounting brackets in
the bottom of the cabinet. Make sure that they are installed tightly to prevent future thread wear.
Condenser Filter Screen
The Condenser Filter Screen, Screen Pull and Filter Guides are packaged inside the unit. The instructions for installing these parts
are included in this technical manual. Do not operate the unit without the filter screen installed!
Pans and Pan Supports
The Pans and Pan Supports are packaged with the unit.
Cutting Board
The Cutting Boards are shipped with the cabinet. The Cutting Boards have two holes in them that allign with studs installed on the
top of the cabinet. To install the Cutting Boards place the back of the boards under the lip in front of the raised rail and set them
down so the studs on the cabinet top allign with the holes in the Cutting Boards. The Cutting Boards are reversible to extend wear.
Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports hook into the Pilasters that are
mounted in the cabinet. The Shelf Supports with the tang go on the rear Pilasters. This shelf system allows for easy adjustment to
suit your needs.
Door Adjustment and Swing
Should the Door ever require straightening, loosen the Screws on the Hinges, square the Door with the cabinet and retighten the
Screws.
Drawers
To remove drawers for cleaning, simply open them fully, lift up on the front of drawer, and pull drawer out. Replace drawers in the
same fashion. With drawer removed the roller members can be removed by rocking the top of the roller member out when the roller
member is pushed all the way to the back of the cabinet. The drawer system is rated for a maximum dynamic load of 275 pounds.
The drawers are not designed or intended as a surface to stand on. At no time should the drawers be extended and used as a
platform for standing on to reach elevated equipment.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the following installation
guidelines must be followed: