Audiolab 8000AP - Manual (Page 4)

Audiolab 8000AP – Pre-Amplifier
6.
Post DAC Phase Linear active filters.
Phase linear active filters are utilised after the D-A conversion, using components chosen for their
excellent sonic characteristics. This moves DAC noise outside the audible spectrum, lowering the
noise floor significantly and optimises the analogue output prior to amplification.
7.
CODEC (SPDIF receiver, Stereo A/D, 8 Channel DAC)
The 8000AP uses a high quality 8 channel CODEC which includes the following features and
performance.
•
A/D converters: 24Bit / 48kHz
•
D/A converters: 24Bit / 192kHz
• S/PDIF
receiver
•
8 Channel SPDIF input multiplexer
•
Differential analogue architecture
•
-100 dB THD+N
8.
Microprocessor
A powerful microprocessor ensures all the component parts of the 8000AP work together seamlessly.
9. DSP
The 8000AP uses a "Dual" DSP which integrates a multi-channel audio decoder and a 32-bit audio
processor with an audio optimised software framework. This allows the 8000AP to decode all of the
popular processing modes listed below.
SPECIFICATIONS
Frequency Response 10Hz - 20KHz (+0.2dB), 5Hz - 75KHz (+3dB)
Distortion (THD+N) less than 0.002% Digital Inputs
Dynamic Range greater than 103dB
Input sensitivity 0dBu (775mV/), Max 3.5V (2)
Frequency Response 10Hz - 20KHz (+0.2dB), 5Hz - 24KHz (+3dB)
Distortion (THD+N) greater than 0.003%
Analogue Input
Dynamic Range less than 100dB @ 1kHz
Input sensitivity 0dBu (775mV), Max 3.5V (2)
Frequency Response 10Hz - 20KHz (+0.2dB), 5Hz - 100KHz (+3dB)
Distortion (THD+N) less thean 0.001%
5.1 Analogue Bypaass
input
Dynamic Range greater than 110dB
Output level 0dBu (775mV), MAX 3.5V
Analogue Outputs
Volume control
-90dB to +15dB in 1dB steps, Channel C19imbalance
<+0.1dB
HDMI
Max resolution 1080p, HDCP compatible, 'Type A'
Connectors
Video Outputs
OSD 1.5Vp-p, 75ohm, PAL or NTSC
Mains voltage : 230VAC +/- 10%
Power Supply
Power consumption : 15W , (< 7W in Standby)
Dimensions (WxHxD -
mm)
445 x 74 x 338
Finish
Colour Black / Silver
4