Silver King SKTTR7 - Manual (Page 3)

3
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to
connecting the unit to power. The specifications on the data plate supersede any future
discussion.
The standard unit is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle,
1 Phase properly grounded electrical receptacle. The power cord comes with a 3 prong plug for
grounding purposes. Any attempt to cut off the grounding spike or to connect to an ungrounded
adapter plug will void the warranty, terminate the manufacturers responsibility and could result in
serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated
on a circuit and not plugged into an extension cord.
OPERATION
Initial start up
After satisfying the installation requirements, the unit is ready to start. The Compressor will start
when the power cord is connected to the required power source. If the Compressor does not start
when the unit is initially plugged in, check to make sure that the Temperature Control is not in the
"off" position. Allow the unit to run for two hours before loading it with product.
Temperature Control
The Temperature Control is located on the back of the cabinet and is factory set to maintain an
average cabinet temperature of approximately 38 to 42 Deg F. on the refrigerator. To obtain
colder temperatures turn the Temperature Control knob clockwise and vice versa. Allow the unit a
minimum of one hour to respond to a control setting adjustment.
Defrost
Your Silver King refrigerator is a manual defrost unit. The unit should be defrosted whenever the
frost layer on the evaporator plate is approximately 1/2 inch thick. To defrost the unit, either turn
the Temperature Control knob to the 'off' position or disconnect the power cord from the electrical
receptacle and prop open the Door. After the frost has melted or come loose, wipe out the cabinet
interior. Do not attempt to scrape or chisel off the frost as you could do irreparable damage to the
unit. You may find it helpful to lay a dry towel in the bottom of the unit to catch the defrost water
as it drips down.
MAINTENANCE
Preventative maintenance is minimal although these few steps are very important to continued
operation and maximizing the life of the appliance.
Cabinet Surfaces
The cabinet interior is impact resistant ABS plastic and the exterior is stainless steel. These
surfaces should be cleaned periodically with a solution of warm water and mild soap and wiped dry
with a soft cloth. Should a surface become stained or discolored, do not attempt to clean with an
abrasive cleanser or scouring pad. Use a soft cleanser and rub with the grain of the metal to avoid
scratching the surface. Do not use chlorinated cleaners on the stainless steel.
Condenser
Periodically, accumulated dust must be removed from the condenser. First, disconnect the unit
from the power supply. Remove the Back Panel. To clear the dust, vacuum or brush the
condenser at the rear of the cabinet. This will need to be done regularly to maintain the
compressor warranty!
P/N 23992
MODEL______________ SERIAL NO.________________ DATE INSTALLED__________________