Atlas Y1878 User Manual
Y1878 fiberoptic illuminator
Y1878 Fiberoptic Illuminator
1 GENERAL SYSTEM DESCRIPTION
1.1 System
Features
The Y1878 300-Watt Xenon light source described herein is specifically designed for use as an illumination source for
fiber optic illumination applications. As a result, the system shall have the following general features:
1.1.1
4 port flush mount design turret for fiber optic light cable connection to fit ACMI, Storz, Wolf, Olympus industry
standard fibers
1.1.2
Simple lamp module replacement with no tools required
1.1.3
Simple power “ON” switch separate from the lamp ignition switch
1.1.4
Standard lamp safety features
1.1.5
Low noise generation
1.1.6
Very high brightness light output.
1.1.7
Even output beam profile
1.1.8
Compact footprint
1.1.9
Quick re-strike in the event that the device shuts down from overheating
1.1.10
Single world-wide universal power supply
2 INTENDED USAGE
2.1 General
This 300 W Xenon light source shall be used as an illumination source to provide light to fiber optic cables or light guides.
Atlas Specialty Lighting
assumes no responsibility for suitability for any particular application of the lightsource
or any consequential damages associated with the use of
the lightsource.
2.2 Personnel
2.2.1
Any trained personnel that has familiarized themselves with the product by reading the operation manual provided
2.3 Sterilization/Disinfection
2.3.1
The light source may be wiped-down with hospital approved disinfectants (e.g. 10% clorox/90% water solution)
applied with a damp cloth.
3 ASSOCIATED EQUIPMENT
3.1
Fiber optic light guides (cables) not provided by Atlas Specialty Lighting
Issue x
2
17 January 2006