Addtron Technology Mercury Hub PR0018 - Manual (Page 6)

Mercury 6-5 M/E Installation guide
Mercury Hub User Guide
Specification
Power requirements:
Supply Voltage Range:
100 - 240 Vac ±10% (Mains version)
Supply Frequency: 50 - 60 Hz (Mains version)
OR 2 x Mercury Controllers connected to ports 1 and 2
Maximum supply current: 500 mAmps
Typical supply current: <100 mAmps
Operating temperature range: +5
0
C to +50
0
C
Operating Humidity: 80% maximum
Storage temperature range: -20
0
C to +65
0
C
Environmental: Indoor use at altitudes up to 2000m, Pollution Degree 1,
Installation Category II.
Voltage fluctuations not to exceed ±10% of nominal voltage
Size: 300mm (L) x 35mm (H) x 110mm (W)
Weight: 300 Grams
Safety: EN61010
EMC: EN61326; 1997 +Amdt. A1; 1998
Ventilation: There is no requirement for forced cooling ventilation
Class 2 Insulation: No protective Earth is required and none should be fitted.
The host equipment must provide a suitable external over-current protection device such as: -
Fuse:
1A 240 Vac Antisurge (T) HRC conforming to IEC 60127
Or MCB: 1A, 240 VAC Type C conforming to BS EN 60898
Mounting
There is a fixing lug at each end of the Hub, with hole centres 317 mm apart. Use typically Number 6 x 1”
Pan head screw with 6mm washer, torque down to 1.5 Newton metres.
RS232 Cable Lengths
Port number
Main Powered Hub Mercury Powered Hub
1 15 metres 5 metres
2 15 metres 5 metres
3 15 metres 15 metres
4 15 metres 15 metres
5 15 metres 15 metres
6 15 metres 15 metres
7 15 metres 15 metres
8 15 metres 15 metres
9 15 metres 15 metres
0 15 metres 15 metres
Ethernet Cable lengths
Port number
Main Powered Hub Mercury Powered Hub
1 Refer to Cat5 standard Refer to Cat5 standard
2 Refer to Cat5 standard Refer to Cat5 standard
Uplink Refer to Cat5 standard Refer to Cat5 standard
Ensure that all power is
switched off before
installing or maintaining
this product
Revision 1.5 Page 6 of 6