Americair HEPA 4000V - Manual (Page 4)

OPERATING INSRUCTIONS
With proper care and maintenance, you will enjoy many years of service
and dramatically improve the quality of your indoor air. The AMAIRCARE HEPA Air
Filtration System is designed to operate continuously and the unit should be left in
operation at all times.
INSTRUCTIONS
1. The unit may be operated in a wide variety of situations. Contact your HVAC
contractor for specific instructions.
2. Plug the unit into a grounded outlet (120 Volt, 60 Hz or 230 Volt 50/60 Hz).
3. Turn the unit on by rotating the control dial clockwise until you hear or feel it
click (Some 4000V and 5000V models only have an on off switch).
4. The unit will come on in the “HIGH” position. To Reduce the air flow, continue
to rotate the control dial clockwise.
5. To turn the unit off, rotate the dial counter-clockwise past the “HIGH” position
until you hear or feel it click.
CAUTION!
1. Make sure that the line cord is not in the path of people walking or where any-
thing can be rolled over it.
2. The unit should be leveled after installation by adjusting the leveler feet.
3. Locate the unit such that there is no possibility of moisture dripping on it.
Moisture could leak into the unit and damage the filter or electrical components.
4. The Air Filtration System discharges clean air through the duct connection on
the top of the unit at the back.
5. Before removing the door of the blower/motor section, disconnect the power
cord.
NOTE: You may notice a slight “new” smell from the Air Filtration System when you
first turn it on. This is normal and harmless and it will dissipate within a few days.