Vaddio Quick-Connect PRO and WallVIEW PRO for AW HE120 - Manual (Page 10)

Quick-Connect PRO and WallVIEW PRO for the AW-HE120 Camera
© 2012 Vaddio - All Rights Reserved. Document Number 342-0497 Rev A Page 10 of 16
Step 7:
Connect the supplied 3’ (.91m) Cat-5 cable to the Control port on the ProductionVIEW controller. Connect the
other end of the Cat. 5 cable to the RS-232 end of the protocol converter (see below). Connect the RS-422 side
of the protocol converter to the Cat-5 cable that is home-run to the AW-HE100 RS-422 port.
Drawing: Detail of Data Conversion
Completing the Installation:
Connect the Vaddio 36 VDC power supply to an AC outlet. Power will travel down the Power Cat. 5 cable to the
EZIM, powering the camera. The camera will “Home” to a centered position ready for control information from
the IR Remote Commander or RS-232 Camera controller of the integrators’ choice. To insure proper continuity
of control and operation of the cameras, the RS-232 controller (control system or joystick) must be powered on
after the camera. Move the camera and test the video.
Optimizing System Performance:
Optimizing the settings will help achieve maximum performance from the system.
Adjust the Y Gain Settings: Enable both Auto Iris and Auto White Balance prior to adjustment. Make sure the
distance adjustment is set at its lowest setting. Adjust the trim pot on the back of the Quick-Connect counter-
clockwise until picture fades or drops out (cable length dependent). Adjust clockwise just past the setting where
picture is restored. Leave the distance adjustment** at its lowest setting unless recommended by Vaddio
technical support.
Note: Y-Gain and Distance adjustments are not active when using the SDI option
Panasonic Manual:
Follow the instruction manual supplied with the AW-HE100 to set up the camera for the lighting conditions that
the camera is installed in (fluorescent, halogen, etc.), as well as the selected output resolution. The Quick-
Connect PRO is configured to work with the camera delivering component HD video.
3’ (.91m)
Cat- 5
Patch Cable
RS-422 Cat.-5 up
to 500’ (152.4m)
Back of AW-HE120
RS-232 to RS-422
Converter ProductionVIEW HD RJ-45F to
DB-9M
RS-232
DB-9F to
RJ-45F
RS-422
RS-422
RJ-45F
RS-232