Vaddio Thin Profile Wall Mount Bracket for CISCO Set-top Codecs - Manual

Vaddio Wall Mount Shelf for TANDBERG Set-top Series Codecs Part Number 535-2000-250 Page 1 of 2
Installation and User Guide
Vaddio™ Wall Mount Shelf for TANDBERG Set-top Series Codecs
For Wall Mounting TANDBERG 990/880/770/550 MXP Set-top Codecs
Model Number 535-2000-250
OVERVIEW:
The Vaddio Wall Mount Shelf for the TANDBERG
set-top series codecs is an attractive and practical
method for mounting Set-top codecs directly to the
wall above plasma displays or above thin-line rear
projection monitors where the codec cannot fit
directly on top of the display. The key features of
the Vaddio Shelf are:
ƒ Designed to fit the contours and geometry of the
codec while echo the design elements
ƒ Encloses the back plane of the codec and hides
the cabling and connectors
ƒ Constructed from lightweight aluminum and
welded for strength and rigidity
ƒ Black powder coat paint provides an attractive,
tough and lasting finish
ƒ Ample space for connectors, cables & adapters
(i.e. DVI to DB-15HD adapter and cable)
ƒ Key-hole mounting holes for speedy installations
and easy camera leveling
ƒ Large access opening in back for full access to
in-wall cabling
UNPACKING:
Carefully remove the product and all of the parts from the packaging. Unpack and identify the following parts:
ƒ One (1) Wall Mount Shelf for TANDBERG Set-top Codec, Part Number 535-2000-250
ƒ Two (2) Black Plastic Mounting Screw Access Caps
ƒ Four (4) #8 x 1- ¼” Sheet Metal Screws
ƒ Four (4) Spiral type drywall anchors
ƒ Manual (Document Number 341-482)
INSTALLING THE WALL MOUNT SHELF:
Note: When locating the set-top codec shelf, consider viewing angles, lighting conditions, possible line of site
obstructions and check for in-wall obstructions where the camera is to be mounted. Pick a mounting location to
optimize the performance of the camera. Read the step-by-step instructions fully before starting the installation.
1. Position the shelf against the wall, level the shelf and mark the hole pattern of the shelf to the wall with a long
pencil. For the top key-holes, mark the top of the key-hole. The hole pattern is shown below (Figure 3).
Camera and Electronic Products for Integrators
Figure 3:
Hole pattern measurements on
the back of the shelf - mark the
top part of the key-hole for
placement of wall anchor, mark
the lower screw holes, and trace
the 11” x 3-½” opening on the
wall with a long pencil.
Figure 2: Rear View of Wall Mount Shelf
Figure 1:
Isometric View of
Wall Mount Shelf
11” x 3-½” cable opening