Vaddio WallVIEW PRO Z330 - Manual

Installation and User Guide
Camera and Electronic Products for Integrators
©2009 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing subject to change. Vaddio,
WallVIEW, EZIM, HSDS, Quick-Connect, and PowerRite are registered trademarks of Vaddio, Inc. All other trademarks are property of their respective owners.
Document Number 341-907 Rev. A
W
ALL
VIEW™ PRO Z330
WITH HSDS™
Vaddio™ PRO Series Cable System for the
Sony® BRC-Z330 High Definition PTZ Camera
OVERVIEW
The Vaddio WallVIEW PRO Z330 (Figure 1) is built around
the Sony BRC-Z330 high definition PTZ Camera with a 1/3-
type, 2 megapixel CMOS image sensor. The WallVIEW PRO
Z330 uses high speed differential signaling (HSDS), an active
transmission system to deliver superior video quality over Cat.
5 cabling distances up to 500 feet.
The WallVIEW PRO Z330 system is capable of 1080i or 720p
HD video. Simultaneous SD video out (crop, squeeze or
letterbox) is available simultaneously but requires an
additional Cat. 5 cable and two Vaddio Quick-Connect boxes.
The WallVIEW PRO system also has many new features, including a unique IR forwarding system which
allows the user to forward IR commands from third party IR remote controls, through the WallVIEW system to
a third party device. Like all Vaddio WallVIEW systems, the Wall Mount and mounting hardware is included.
INTENDED USE
Before installing the Vaddio WallVIEW PRO Z330 Camera System, please read the entire manual thoroughly.
All Vaddio camera systems were designed for use indoors. Outdoor operation is not recommended, has not
been tested, and could damage the camera and/or create a potentially unsafe operating condition. Use only
the Vaddio PowerRite power supply provided.
SAVE THESE INSTRUCTIONS
The information contained in this manual will help you install the Vaddio WallVIEW PRO systems. For
reference, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product
drawings for the Vaddio product line on the website. These documents can be downloaded from
www.vaddio.com free of charge.
IMPORTANT SAFEGUARDS
Read and understand all instructions before using. Do not operate any electrical device if it has been
dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To
reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid
conditions.
INFORMATION
For RS-232 control information, please see the full-length Technical Manual for the SONY BRC-Z330 model.
This manual can be found either on the Vaddio or Sony website. Vaddio has also prepared a number of
TechNotes, specifications and drawings designed to inform and educate integrators on the value and the
specific uses of Vaddio products.
Figure 1:
WallVIEW PRO Z330 System with Camera,
Wall Mount and EZIM (behind camera)
Use only the power supply provided with the WallVIEW PRO Z330 system.
Use of any unauthorized power supply will void any and all warranties.
Do not use “pass-thru” RJ-45 connectors. Use standard RJ-45 connectors for
best results.