AstroStart 803U - Manual (Page 6)

4
THE REMOTE CONTROL
Your remote control works off a small, long-life 12-volt alkaline battery (27A).
The range of your remote control can be affected by a weak battery, interference from nearby metal structures, hydro poles,
or crowded parking lots.
With its electronic CODE LEARNING feature, up to four remote controls can be programmed for your vehicle.
We strongly recommend that you keep a replacement battery in your glove compartment.
See your dealer for replacement batteries or additional remote controls.
USING YOUR REMOTE CONTROL
To ensure that commands are transmitted properly, press desired button
for 2 seconds. A command will not be executed if you do not press
button long enough.
Indicator light will flash while transmitting the command.
Your system can be configured (during installation) in such a way that
the remote control will only access the starting function of your vehicle or
it can access both the starting and door locking functions of the vehicle.
You can replace the buttons (rubber keypad) of your remote control by
an alternate keypad (ask your dealer).
The keypad shows pictograms to help you remember the commands;
use the keypad that corresponds to your system options.
Remote(s) included in kit may differ from the ones illustrated.
TABLE OF COMMANDS
C OMMANDS B UTTONS C ONFIRMATION
S ELECTED OPTION ⇒ O PTION 1 O PTION 2 L IGHTS H ORN
S TOP 1
S TART / C ONTINUOUS M ODE 1 ™ 1 ™
A CTIVATE / D EACTIVATE S ENTINEL M ODE 4 / 2 / 3 š
T RUNK 3
U NLOCK 2
L OCK 1 1 ›
™ T HIS CONFIRMATION IS SENT ONLY WHEN ENGINE IS ALREADY RUNNING UNDER REMOTE CONTROL .
š 4 = A CTIVATION / 2 = D EACTIVATION / 3 = S YSTEM NOT READY
› P ROGRAMMABLE DURING INSTALLATION – 2 ND LOCK
Note : Make sure that the remote control is covered with the appropriate keypad, i.e. pictograms that correspond with the
command options programmed to your system (See “ Using your remote control”).
Option 1 Option 2