Advanced Technology LuxCore - Manual (Page 2)

ATI-LII Revision 1 Effective Date: 3/13/12
Advanced Technology, Inc. (800) 849-1320 Page 2 of 5
Trowel Application
 PVC Moldings
 Silicone Sealant
 Soap, Water, & Damp Cloth for Panel Clean-Up
 Mineral Spirits to Remove Excess Adhesive or Silicone Sealant
STORAGE
Panels should be stored inside in a cool, well-ventilated, dry area on the original
shipping pallet. Do not place panels on a concrete floor or any other surface that
emits moisture. Panels should be laid flat, not on edge. Panels should be climatized
in the area they will be installed for a minimum of 24-48 hours.
ADHESIVE
For applications requiring adhesive, suggestions include Weldwood®
non-flammable, water-based contact cement (applied by spray,
brush, or roller), or Titebond® Advanced Polymer Panel Adhesive
(applied with a notched trowel). Titebond® Panel Adhesive
should be applied in a crosshatch pattern, enabling even
distribution of substrate (See Figure to the right). For best results,
Titebond® panel adhesive should be stored above 50°F.
Due to the abrasive nature of the adhesive, it is highly recommended
that those working with the adhesive wear protective safety
equipment which include, but are not limited to the following: safety
glasses, gloves, and a filter mask.
FASTENERS
Nylon drive rivets, or corrosion resistant screws are appropriate fastener options. If
fasteners will be used in the installation, panels should be pre-drilled using a drill bit
that is 1/8”-1/4” larger than the fastener. During installation, holes drilled into the
substrate should also be made 1/8”-1/4” larger. This is required to allow room for
expansion and contraction of the panels.
EXPANSION JOINTS
As temperature and humidity levels fluctuate, LuxCore panels will expand and
contract. Therefore, adequate space must be allowed around panel edges, holes
drilled in panels, and around fixtures attached to the panel/wall. Please refer to the
expansion joint chart below for spacing at ceiling, floor and between panels.