Akai synthstation_studio - Manual (Page 7)

(3) Touch a number on the 64-number grid below to assign that Sound to the selected
Synth. The Sound's name will be displayed on the left. To select a different number,
touch another number or touch PREV or NEXT to move through the Sounds
sequentially.
(4) When you are finished, repeat Steps 3-5 or touch MENU to go to another page.
Touch and hold a Sound number to bring up a window in which you can:
SAVE: Saves the Sound.
COPY: Copies the Sound.
PASTE: Pastes a copied Sound over the current one.
CLEAR: Deletes the Sound.
CANCEL: Closes the menu.
MIXER
The Mixer Page allows you to adjust the fader levels of the Drum Kit, Synth 1, Synth 2,
and Synth 3 as well as Send levels and the Master Volume.
Touch anywhere along the fader line to make it "jump" to that point or touch and slide a
fader to adjust it.
To adjust the Send levels, touch the knob and slide up or down. You can make it
automatically "jump" to the maximum level by double-tapping it.
To mute a part, press the corresponding button at the bottom of the fader. The button
will be red when muting. (Note: This will mute the MIDI of a part but not the audio, so
some notes may trail off after muting the part before it actually falls silent.)
Touch the FX CONFIG button at the top of the page to jump to the Effects Page (where
you can easily jump back to the Mixer Page by pressing the Mixer shortcut button).
X/Y
The X/Y Page contains both a standard X/Y pad and Joystick controller, which changes
the modulation of your synths. Press the X/Y PAD or JOYSTICK button to select the
view. (Note: The parameters affected by the X/Y controller can be found in the XY MOD
area of the Synth Edit Page.)
Note: When the DRUM part is selected, certain features in the app will be disabled
because they do not apply to the drums. These include the Synth Edit Page controls,
the X/Y controls, and inapplicable faders on the Perform Page.