Bike haven – American Bicycle Security Company Bike Haven User Manual
Page 5
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Bike Haven
Installation Instructions –
Starter Section
Installation Steps:
4. Place the initial ROOF PANEL at one end of the assembly.
The panel should cover both openings at the top of the
uprights. With a self-drilling screw, drill through the ROOF
PANEL and ROOF MEMBER LONG in noted points. You may
want to clamp a wood 2x4 to both UPRIGHT SHORTS at
the level of the ROOF panel, so that all the ROOF PANELS
stay aligned with each other. Place the next ROOF PANEL
in place, drill where noted. Repeat with the rest of the
ROOF PANELS. ROOF PANELS should overlap by the noted
amount. The last ROOF PANEL may overlap more.
5. Drill ½” holes in the ground at the four slotted holes in the
UPRIGHTS and secure the UPRIGHTS with ½” wedge anchors.
If adding side panels, continue to step 6.
6. ADDING SIDE AND REAR PANELS Place the REAR PANEL in
place and clamp it to the UPRIGHT SHORTS. Using the
four ½” holes in the REAR PANEL as a guide, drill through
both walls of the UPRIGHT SHORTS with a 3/8” drill bit.
7. Bolt the REAR PANEL to the UPRIGHT SHORTS with the
aluminum spacers in between the REAR PANEL and
UPRIGHT SHORTS.