Mr rack – American Bicycle Security Company MR Series User Manual
Page 3
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
MR Rack
*Tools Needed for Installation
9/16” Socket set
Two 4”x4”x28” (or larger) blocks
4 bolts, nuts and washers for every
Hoop (included with rack). If using a
tamper resistant nuts, install two
tamper resistant nuts with each rack.
The MR Rack is easy to install. The rack can be
bolted down or can be left freestanding.
Each MR Rack consists of five pieces:
• One main body
• Two tire catches
• Two feet channels
What you will need to install your MR Rack:
• 9/16” wrench
• Four 4”x4” blocks (or something similar in size)
* Installation instructions are the same for all
sizes of MR Racks*
Installation Steps:
1. Place blocks under feet channels
2. Place main body on feet channels so that the
two middle holes line up. Apply nuts and
bolts and tighten.
3. Place tire catches so ends line up with first
set of holes. Apply nuts and bolts and
tighten. The second set of holes can be used
to anchor the rack to the ground if desired.
Installation
Installation Steps: