American Electric Lighting IN-282 - Manual

IN-282
IMPORTANT SAFETY INSTRUCTIONS
•
• To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and
other hazards please read all warnings and instructions included with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
• Installation and service of luminaires should be performed by a qualified licensed electrician.
• Maintenance of the luminaires should be performed by person(s) familiar with the luminaires’ construction and operation
and any hazards involved. Regular fixture maintenance programs are recommended.
• It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on ambient
dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed in a solution of warm
water and any mild, non‐abrasive household detergent, rinsed with clean water and wiped dry. Should optical assembly
become dirty on the inside, wipe refractor/lens and clean in above manner, replacing damaged gaskets as necessary.
• DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have been
damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should be replaced.
• If the lamp is marked (Hg) it contains Mercury. Follow all disposal laws. See www.lamprecycle.org.
• These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency
to meet in connection with installation, operation, or maintenance. Should further information be desired or should
particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, this matter should be
referred to Acuity Brands Lighting, Inc.
Failure to follow any of these instructions could void product warranties.
For a complete listing of product Terms and Conditions, please visit www.acuitybrands.com.
Our Brands
Indoor/Outdoor Indoor Lighting Outdoor Lighting Controls
Lithonia Lighting Gotham American Electric Lighting DARK TO LIGHT
Carandini Mark Architectural Lighting Antique Street Lamps Lighting Control & Design
Holophane Peerless Hydrel ROAM
RELOC Renaissance Lighting Tersen Sensor Switch
Winona Lighting Synergy
Acuity Brands Lighting, Inc. assumes no responsibility for claims arising out of improper or careless installation or handling of its products.
© 2011 Acuity Brands Lighting, Inc. All rights reserved. 05/24/11 ABL General Warnings, Form No. 503.204
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
9 Disconnect or turn off power before installation or
servicing.
9 Verify that supply voltage is correct by comparing it
with the luminaire label information.
9 Make all electrical and grounded connections in
accordance with the National Electrical Code (NEC) and
any applicable local code requirements.
9 All wiring connections should be capped with UL
approved recognized wire connectors.
WARNING
RISK OF ELECTRIC SHOCK
9 Allow lamp/fixture to cool before handling. Do not
touch hot lens, lamp, guard, or enclosure.
9 Do not exceed maximum wattage marked on luminaire
label.
9 Follow all lamp manufacturer’s warnings,
recommendations and restrictions on lamp operation
including but not limited to: ballast type, burning
position, replacement, and recycling.
9 Use only lamps that comply with ANSI standards.
WARNING
RISK OF BURN
9 Wear gloves and safety glasses at all times when
removing luminaire from carton, installing, servicing or
performing maintenance.
9 Avoid direct eye exposure to the light source while it is
on.
CAUTION
RISK OF INJURY
9 Keep combustible and other materials that can burn
away from lamp/lens.
9 Do not operate in close proximity to persons,
combustible materials or substances affected by heat
or drying.
CAUTION
RISK OF FIRE