American Electric Lighting Series 11 & 11 Package - Manual

INSTALLATION INSTRUCTIONS
SERIES 11 & 11 PACKAGE
American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA
DRAWING NO. A71964 REV A (FRONT) ©2007 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-71-71964
1. FEED THE FIXTURE WIRES THROUGH THE MOUNTING
ARM, SLIDE THE FIXTURE ONTO THE MOUNTING ARM
UNTIL IT IS FULLY ENGAGED, AND TIGHTEN THE FITTER
BOLTS "A" SECURELY.
2. LEVEL FIXTURE USING STEPS SEE ILLUSTRATION.
1. FASTEN THE MOUNTING ARM AND CLAMP ASSEMBLY INTO
PLACE, USING THE FOUR LAG SCREWS SUPPLIED. TIGH-
TEN THESE SCREWS SECURELY.
INSTALLING THE MOUNTING ARM INSTALLING THE MOUNTING ARM
INSTALLING THE OPTICAL ASSEMBLY & LAMP INSTALLING THE OPTICAL ASSEMBLY & LAMP
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
HOUSING MUST BE GROUNDED TO REDUCE POTENTIAL OF ELECTRICAL SHOCK
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION
WARNING
!
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. FOR CODE INTERPRETATION,
CONSULT LOCAL CODE AUTHORITY BEFORE INSTALLING VERIFY THAT THE SUPPLY VOLTAGE
MATCHES THAT REQUIRED BY THE FIXTURE AS SPECIFIED ON THE DATA LABEL.
RISK OF FIRE. PRODUCT FOR OUTDOOR INSTALLATION AND USE ONLY.
WARNING
CAUTION
!
!
CAUTION
THE MOUNTING ARM IS NOT DESIGNED TO
SUPPORT THE WEIGHT OF A PERSON.
!
1. FOR OPTIC WITH LATCH OPTION. ATTACH SPRING LATCH
OF OPTIC TO THE TABS ON THE SIDE OF THE HOUSING
PULL LATCH HANDLE DOWN TO LOCK IN PLACE.
2. SCREW BULB INTO BULB SOCKET UNTIL BULB IS FIRMLY
SEATED.
NOTE FOR MH LAMP WIRE MESH MUST BE INSTALLED
TO MITIGATE POTENTIAL FOR NON-PASSIVE FAILURE
OF MH LAMP.
MOUNTING THE FIXTURE MOUNTING THE FIXTURE
WARNING
!
THE FIXTURE IS SUPPLIED WITH A STANDARD LAMP,
WHICH CAN CAUSE SERIOUS SKIN BURNS AND EYE
INFLAMMATION IF IT IS OPERATED WHEN THE OUTER
GLASS JACKET OF THE LAMP IS BROKEN. IF THE GLASS
SHOULD BREAK DURING OPERATION, DISCONNECT THE
POWER TO THE FIXTURE AND REPLACE THE DEFECTIVE
LAMP IMMEDIATELY. TO INSTALL THE LAMP, SCREW IT
INTO THE LAMP SOCKET UNTIL IT IS FIRMLY SEATED
MAST ARM MAST ARM
2" WASHER 2" WASHER
2-1/4" WASHER 2-1/4" WASHER
NOTE: 2-1/4" SPECIAL ONLY NOTE: 2-1/4" SPECIAL ONLY
BOLT WITH NUT BOLT WITH NUT
4" LAG BOLT (1) (2) 4" LAG BOLT (1) (2)
3" LAG BOLT (1) (2 3" LAG BOLT (1) (2 ))
WASHER WASHER
BOLT BOLT
LEVELING STEPS
MAST ARM
OPTIONAL OPTIONAL