American Electric Lighting 882 - Manual

INSTALLATION INSTRUCTIONS
882 SERIES SIDELITE LUMINAIRE
American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA
DRAWING NO. B23848 REV C (FRONT) ©2004 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-70-23848
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
REAR HOUSING MUST BE GROUNDED TO REDUCE POTENTIAL OF ELECTRICAL SHOCK
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL
AND LOCAL ELECTRICAL/BUILDING CODES. FOR CODE INTERPRETATION, CONSULT LOCAL CODE AUTHORITY
RISK OF FIRE. PRODUCT FOR OUTDOOR INSTALLATION AND USE ONLY.
WARNING
CAUTION
!
!
!
LOOSEN (2) CAPTIVE SCREW "A" UNTIL FREE. REMOVE FRONT HOUSING ASSEMBLY.
LOOSEN (2) REFLECTOR SCREW AND REMOVE REFLECTOR AND BARRIER.
AFTER FIXTURE INSTALLATION, REPLACE BARRIER AND REFLECTOR.
1. DRILL OR KOCKOUT (3) 5/16"HOLES IN BOSSES PROVIDED
ON BACK OF REAR HOUSING.
2. REMOVE THREADED PLUG FROM WIRING ACCESS HOLE.
3. SECURE FIXTURE TO WALL. USE 1/4" DIA. SCREWS MIN.
REFER TO LAYOUT BELOW FOR HOLES LOCATION.
4. CONNECT SUPPLY LEADS TO FIXTURE LEADS.
GROUND FIXTURE WITH GROUND WIRE PROVIDED.
KEEP WIRE CONNECTIONS INSIDE JUNCTION BOX.
1. DRILL OR KNOCKOUT (3) 5/16" HOLES IN BOSSES
PROVIDED ON BACK OF REAR HOUSING.
2. SECURE FIXTURE TO WALL. USE 1/4" DIA.
SCREWS MIN. REFER TO LAYOUT BELOW FOR HOLES
LOCATION.
3. REMOVE PLUG(S) AND THREAD CONDUIT TO ONE OR
BOTH SIDES OF FIXTURE.
4. CONNECT SUPPLY LEADS TO FIXTURE LEADS. GROUND FIXTURE
WITH GROUND WIRE PROVIDED. KEEP WIRE CONNECTIONS
INSIDE REAR HOUSING.
FIG.1
A. FOR DIRECT MOUNTING TO EXISTING FLUSH JUNCTION BOX:
B. FOR DIRECT MOUNT/WITHOUT JUNCTION BOX:
5. CAULK AROUND JUNCTION BOX WITH A SILICON
TYPE CAULKING TO PROVIDE A WATER-TIGHT SEAL.
PHOTOCONTROL
(OPTIONAL)
REAR HOUSING
FRONT HOUSING
ASSEMBLY
SCREW "A"
MOUNTING HOLES
MOUNTING HOLE
C OF FIXTURE
ACCESS HOLES
HOLES LAYOUT
2
3/
4
2
3/
4
6 6
7/
8
L