AZEK Trim & Moulding EN - Manual

AZEK Trim & Moulding
Install Guide
TRIM MOULDING DECK PORCH RAIL PAVERS
Storage & Handling, Cutting, Drilling, Routing ............................................................................ 2
Fastening, Expansion & Contraction .............................................................................................. 3
Painting, Gluing .................................................................................................................................. 4
Spanning, Water Table ..................................................................................................................... 5
Garage Door Thermostop, Rabbeted Cornerboard .................................................................... 6
Universal Skirt Board, Integrated Drip Edge ................................................................................ 7
Installing Finish Grade Trim ............................................................................................................. 8
Notes ....................................................................................................................................................10
• These guidelines cover the general installation recommendations for AZEK Trim and AZEK Moulding. See
specific installation information for Universal Skirt Board, Integrated Drip Edge, Rabbeted Cornerboard,
Column Wrap, Finish Grade Trim, Water Table, and Garage Door Thermostop.
• AZEK Trim and AZEK Mouldings should be installed using the same good building principles used to install
wood trim and mouldings and in accordance with the local building codes and the installation guidelines in-
cluded below. AZEK Building Products Inc. accepts no liability or responsibility for the improper installation
of this product.
• AZEK Trim and AZEK Moulding may not be suitable for every application and it is the sole responsibility of
the installer to be sure that AZEK Trim and Mouldings are fit for the intended use. Since all installations are
unique, it is also the installer’s responsibility to determine specific requirements in regards to each trim and
moulding application.
• AZEK Building Products recommends that all applications be reviewed by a licensed architect, engineer or
local building official before installation. If you have any questions or need further assistance, please call
AZEK Customer Service at 877-ASK-AZEK (877-275-2935) or visit our website at www.azek.com.