Beijer Electronics iX T21C EN - Manual (Page 15)

Hardware Replacement
3.4 Replacing the Battery
The following is needed:
• A new BR 2032 (or CR 2032) battery.
• A Torx screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the battery:
1. Power off the operator panel.
2. Follow the instructions in chapter
Replacing the Fan and Filter to remove the
fan and access the battery.
3. Replace the battery.
4. Reassemble in reverse order.
Beijer Electronics, MAEN084D 15