Beijer Electronics DT150 EN - Manual (Page 16)

Technical Data
Beijer Electronics, MAEN844D 15
3.2 Operation Messages
The following operation messages will be displayed under different
circumstances:
3.3 Video Input Timing
The following vertical refresh rate is recommended:
3.4 Audio Support
The industrial monitor has a built in stereo amplifier that can be controlled ei-
ther via the OSD interface or the OSD buttons on the rear side. The monitor is
equipped with one audio input port and one speaker out port.
Operation
message
Explanation
AUTO TRACKING Auto Tracking (analog RGB mode):
Executes auto function
NO SIGNAL Self diagnostics (analog RGB mode):
No input signal after power-on with power switch.
The message will disappear after 10 seconds of activity of
input signal.
NO SUPPORT Out of Range:
The input signal exceeds the supported range.
Mode Refresh rate
1024 x 768 pixels 60~75 Hz
Sync.: H/V separated TTL
Parameter Specification
Maximum output 2 x 2W @ 8 Ω
Note:
The industrial monitor does not include built-in speakers.