Beijer Electronics EXTER T150 EN - Manual (Page 16)

Chemical Resistance
16 Beijer Electronics, MAEN775C
Autotex withstands DIN 42 115 Part 2 exposure of up to 1 hour duration to glacial
acetic acid without visible change.
Autotex is not resistant to high pressure steam at over 100
°
C or the following
chemicals:
Outdoor Use
In common with all polyester based films Autotex F157/F207 is not suitable for use
in conditions of long term exposure to direct sunlight.
4.2.2 Touch Screen Surface
The touch screen surface on the panel withstands exposure to the following solvents
without visible change:
4.2.3 Autoflex EB
It is recommended to use the Autoflex EB touch display protection film, that can be
ordered from Beijer Electronics.
Solvent Resistance
Autoflex EB withstands exposure to the same chemicals as Autotex F157 or F207
according to section
Autotex F157/F207 .
Outdoor Use
In common with all polyester based films Autoflex EB is not suitable for use in
conditions of long term exposure to direct sunlight.
Acetic acid (<50%) Gumption 1 SBP 60/95 1
Ariel powder in solution 1 Hydrochloric acid (<36%) Sulfuric acid (<10%)
Bleach 1 Linseed oil Tomato ketchup
Castor oil Methanol Trichloroacetic acid (<50%)
Caustic soda (<40%) 1 Nitric acid (<10%) White Spirit
Cutting oil Paraffin oil
Windex 1
Cyclohexanol Persil powder in solution 1 Wisk
Diacetone alcohol
Petroleum spirit 1 -
1 Extremely faint glossing of the texture was noted.
Concentrated mineral acids Benzyl alcohol
Concentrated caustic solution Methylene chloride
Solvents Time
Acetone 10 minutes
Isopropanol 10 minutes
Toluene 5 hours