3 replacing the rear cover, Replacing the rear cover – Beijer Electronics iX Panel K60 EN User Manual
Page 21
Advertising
Hardware Replacement
7.3 Replacing the Rear Cover
The following is needed:
•
A new rear cover, see
Available Spare Parts for iX Panel K60
•
A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the rear cover:
1. Power off the operator panel.
2. Follow the
instructions to remove the battery.
3. Remove the rear cover of the operator panel by loosening the 4 torx screws.
4 x torx screws
4. Re-assemble with the new rear cover in reverse order.
Beijer Electronics, MAEN001
21
Advertising