Decolav 5230 - Manual (Page 9)

CAMERON MODULAR SERIES
Customer Service: 561-274-2110
www.decolav.com LET YOUR DREAMS COME ALIVE, YOUR PASSIONS
BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS ®
9
INSTALLING THE TOP TO THE VANITY
o With the vanity in the desired location Place a small bead of silicone to the areas shown in Figure G.
o Carefully lower top into position. There will be approximately 1/4 inch of top overhang on either side of
the top. Back of top should be aginst the wall
o Apply a bead of silicone to the bottom edge of the backsplash and to the back of the backsplash.
Apply backsplash to the back of the vanity top and the wall.
o Let Silicone Cure per manufactures specifi cation before using.
Step #1
Use Silicone on the Bottom and the
Back Edge of the Backsplash
Apply a Small Amount of Silicone to the
areas shown
INSTALLING THE TOP ON THE VANITY CONSOLE/ VANITY DRAWER
o Apply a small amount of Silicone to the areas shown. Figure I
o Because of the decorative moulding that is directlly below the Vanity top the Drawer Console top and the
Vanity drawer top must be slid in from the front. See Figure I
o The back edge of the Vanity drawer and Drawer Console should be fl ush with the back of the Vanity Drawer
chassis and the back of the Drawer console Chassis
Step #1
Drawer Console
Apply a Small Amount of Silcone
to the areas shown
Figure I
Vanity
Vanity Top
Backsplash
Figure H
Apply a Small Amount of Silcone
to the areas shown
Vanity Drawer Top
Vanity Drawer
Drawer Console Top