Fagor 3CF-540SI BUT - Manual (Page 40)

40
- the brown wire to phase
- the lead must never touch hot surfaces over
about 75 degrees C;
- replacement leads must be of type H05RR-
F or H05V2V2-F of suitable size (see dia-
grams in fi g. 2).
- if the appliance is supplied without lead,
using type H05RR-F or H05V2V2-F cable
of suitable size (see diagrams in fi g. 2).
IMPORTANT: the manufacturer declines all
liability for damage due to failure to comply
with the regulations and standards in force.
Check that the appliance is correctly con-
nected to the earth (see diagrams in fi g. 2
at the back of the manual).
THE SAFETY DEVICE
The correct gap between the end of the ther-
mocouple sensor and the burner is shown
in fi gures 5 and 6.To check that the valve is
working properly, proceed as follows:
- ignite the burner and leave it to work for
about 3 minutes;
- turn off the burner by returning the knob to
off position ( );
- after 60 seconds for oven and grill burners,
turn the knob pointer to the "on" position;
- release the knob in this position and move
a burning match towards the burner; IT
MUST NOT IGNITE.
Time needed to excite the magnet during
ignition: 10 seconds approx.Automatic trip-
ping time, after fl ame has been turned off:
not more than 60 seconds for oven and grill
burners.
IMPORTANT:
- Before doing any work inside the cooker,
disconnect the mains plug and shut the gas
tap.
- Never use matches to check the gas circuit
for leaks. If a specifi c control device is not
available, foam or very soapy water can be
used.
- When re-closing the hob, check that
the electrical wires of the spark plugs (if
present) are not close to the injectors, so
that they cannot run across them.
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat
and moisture in the rooms where they are
installed. Take care to ensure that the
kitchen is well ventilated; keep the ventilation
openings unobstructed or install an extractor
hood with fan.
In case of intensive or prolonged use, ad-
ditional ventilation may be required; open
a window, or increase the extractor fan
power.
IGNITING THE HOB BURNERS
- Press the knob and turn it anti-clockwise
until it reaches the symbol on the control
panel (maximum fl ame position);
- at the same time, move a burning match
towards the burner head;
- to reduce the fl ame, turn the knob further in
the same direction until its pointer is against
the symbol (minimum fl ame position).
IGNITING THE OVEN BURNER
- Open the oven door;
- press the knob and turn it anti-clockwise to
the maximum fl ame position;
- move a burning match towards the hole in
the centre of the oven bottom and press the
knob right down (see fi g. 9);
- look through the two holes in the sides of
the bottom to check that the burner has
ignited, keeping the knob pressed down;
- after about 10 seconds, release the knob
and check that the burner remains on.
Otherwise, repeat the operation.
IGNITING THE GRILL BURNER (GAS
GRILLS)
- Fit the control knob guard as shown in fi g.
12;
- press the oven knob and turn it to the right
until it reaches the stop;
- move a burning match towards the perfo-
rated burner pipe and press the knob right
down (see fi g. 10);
GB Installation For the user