Fagor ML-300 - Manual (Page 7)

6
3. INSTRUCTIONS FOR USE
Maximum capacity: 65g.
Never overfill the grinder.
After placing the coffee beans in the
grinder, close the transparent lid and make
sure that it is properly in position.
Plug the appliance into the mains and then
press and hold the start – stop button to
initiate the grinding operation.
Unplug the appliance after use.
Warning: Do not hold the start –stop
button down for longer than a minute at
a time, as this may cause the motor to
overheat.
4. CLEANING INSTRUCTIONS
Always unplug before cleaning.
The grinding compartment should be
cleaned after each use in order to avoid
the built up of old coffee which may taint
subsequent beans.
Clean the grinding compartment with a
damp cloth and dry well. The lid should
be cleaned with hot, soapy water. Dry
thoroughly before replacing.
5. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not
be disposed of as urban
waste. It must be taken to
a special local authority
differentiated waste
collection centre or to a
dealer providing this service. Disposing of
a household appliance separately avoids
possible negative consequences for the
environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to
obtain significant savings in energy and
resources.
To remind you that you must collaborate
with a selective collection scheme, the
symbol shown appears on the product
warning you not to dispose of it in
traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.