Fagor BBCP-801G - Manual (Page 11)

10
• Turning the knob to the position 0 turns
off the grill plate.
5. MAINTENANCE AND CLEANING
6. MAINTENANCE AND SERVICING
(ONLY FOR QUALIFIED TECHNICIANS)
• To clean the plate is advisable to pour
a little cold water on it a few minutes
after turning the grill off. The water will
facilitate the removal of scraps stuck
to the plate. Afterwards, clean it with
a damp cloth, and after it cools down,
and only if necessary, a small amount of
detergent can be used.
• This must be done each time after the
grill plate is used.
• The tray (3), which is located in the front
of the device, must be taken out regularly
and cleaned, in order to avoid spilling
grease on the knobs. To remove it, to
push it up a little and then push it out.
In order to alter the type of gas, do the
following:
• Close the gas alimentation tab and take
off the alimentation tube.
• Turn the equipment upside down. In
this position, the grill plate is turned
downwards, the inferior part upwards.
The inside of the equipment is now
visible. (Fig.2)
• In order to take out the burner, push
it a bit to the back of the equipment
and this loosens the burner from the
aluminium part. The injector (5) becomes
accessible and it can be replaced. Use
an adequate nut driver to take it out.
Attention: Keep in mind the relation
between the diameter of the injector's
hole and the type of gas.
Note: In order to test the equipment, turn
the equipment into working position. After
every alteration of the type of gas, you
must regulate the air flow and regulate the
minimal position of the tab.
• Pull out the tap knobs (2).
• Through the inner part, using a
screwdriver, unfasten the two screws
that fix the frontal part of the device.
(Fig. 2).
Regulate the minimal position of the tap
with the burner burning. Turn the tab
to the minimal position, take off the tap
handle and then fasten or unfasten the
frontal screw of the tap (6) (at the left of
the tap) in order to adjust the flame size
to the minimum. Be careful not to turn off
the flame and allow the thermocouple to
receive heat (otherwise it will close the tap).
After defining the minimal position of the
tap, wait ca. 2 minutes to make sure the
flame keeps burning.