Hawk Industries Hawkjaw Sr. Manual M100K-2GSR Serial Numbers 201 to 370 - Manual (Page 25)

Operation 23
1. Press in the Grip Hold (GH) button.
2. Press and hold Spin (S) until the
stand rotates down to the shoulder.
3. Release Spin (S).
4. Push in and hold the wrench Grip
(G).
5. Push and hold down Torque (T).
6. Watch the Torque gauge needle (TN).
7. When the Torque gauge needle rises
above and settles at the desired
torque (this rising above is a normal
hydraulic adjustment), release
Torque (T). Immediately release
Torque (T) button and the wrench
Grip (G) button.
7a. Note: If the desired torque is not
achieved, repeat steps 4-7.
8. Pull out the Grip Hold (GH) button.
9. The Hawkjaw can now be removed
from the pipe.
SEE LOW TORQUE WARNING
SYSTEM CHECK PG. 24
Make Up Make Up
G GH
T S