MIPRO ACT-82a Wideband Dual-Channel Digital Receiver - Manual (Page 12)

Receiver to transmitter frequencies
are synced automatically.
Setting ACT Transmitter Frequency BA: Transmitter Battery Meter (receiver display)
Press ACT button
Indicates the frequencies did not sync successfully. Ensure the IR windows in both the receiver and transmitter are
lined up and can “see” each other, then press the ACT button again.
ACT indicator illuminates
GRP CH BAND ANT
MHz ACT RF AF
SQ BA
EQ ADD
Press the “ACT” button once to activate the ACT sync function. Once activated, the words “ACT” and
“Sync” on the receiver will illuminate. Flashing will stop when the IR signal is received by the handheld
or bodypack transmitter or no IR signal is received within 10 seconds.
The battery meter illuminates when the transmitter is powered ON. The LCD battery meter gives a
percentage (%) indication of remaining battery life, as shown above. Recharge the transmitter battery
(or replace with a charged battery pack) immediately when battery indicators fall to 10% (1 bar
showing as indicated above).
To Activate:
To Cancel:
! When the words “ACT” and “Sync” on the receiver illuminate, press the ACT button again.
! When the words “ACT” and “Sync” on the receiver illuminate, do not press any button. ACT function
will stop and cancel automatically after about 10 seconds.
Instructions:
1. Ensure a receiver channel is set up (Group / Channel), the transmitter battery is charged and the
transmitter is powered ON.
2. Press the ACT button on the receiver to activate the ACT function. Once activated, the words ACT
and Sync will illuminate.
3. Bring the ACT handheld or bodypack transmitter within 30cm (12”) of the IR port on the receiver
(check your transmitter documentation to find out where the IR port is located on the transmitter).
The receiver IR port is located behind the “ACT” button and indicated by a round dark red dot.
The transmitter/receiver frequency will sync automatically.
NOTE: If encryption is turned on, the ACT function will also send a new encryption key to the transmitter and
lock it. To unlock the transmitter it is necessary to re-sync the transmitter again using ACT with the receiver in
“Encryption OFF” mode.
100% 90% 80% 40% 10% 0%
BA BA BA BA BA BA
18 19
Encrypted Digital Wideband Diversity Receiver Encrypted Digital Wideband Diversity Receiver
GRP CH BAND
L
ANT
MHz ACT RF AF
SQ BA ADD EQ
GRP CH BAND
L
ANT
MHz ACT RF AF
SQ BA ADD EQ a
or
< 3
0cm
(1
2 in
.)