MIPRO ACT-51 Single-Channel Diversity Receiver - Manual (Page 9)

To Set Channel via AutoScan:
1. Press and release the button once. The RF meter cursor starts blinking to
denote it is ready to accept parameter changes.
2. During blinking, press and release the or button once will AutoScan
and stop at one of 8 preset interference-free channels.
3. Press and release the button once to confirm the change. The RF meter
cursor stops blinking and the new channel is now stored into memory.
CHANNEL setting CH
AF
A
1 2 3 4 5 6 7 8 SQ
MHz
GRP BAT
ACT MENU
MENU
MENU
Press once to increase
by one channel
Blinking RF cursor
Press Once Press once to decrease
by one channel
During blinking RF cursor: Press ▼ or ▲ button to start AutoScan
AF
A
1 2 3 4 5 6 7 8 SQ
MHz
GRP BAT
Press once and release
ACT MENU
1. AutoScan mode deactivates automatically if or button is not pressed
within 5 seconds. The VFD panel dims automatically, too.
To exit AutoScan mode:
12 13
Diversity Receivers Diversity Receivers
1. Press and release the button once. The RF meter cursor starts blinking to
denote it is ready to accept parameter changes.
2. During blinking, press and hold the or button. Pressing the or
button will decrease or increase the channel setting by one.
3. Press and release the button once to confirm the change. The RF meter
cursor stops blinking and the new channel is now stored into memory.
Manual model deactivates automatically if or button is not pressed within 5
seconds. The VFD panel dims automatically, too.
To exit Manual mode:
To Set Channel Manually:
Press and hold
AF
A
1 2 3 4 5 6 7 8 SQ
MHz
GRP BAT
ACT MENU
During blinking RF cursor: Press and hold ▼ or ▲ button for manual channel
MENU
MENU